The 1051S is more than prepared to feed a big, power-hungry subwoofer all it can handle; this beast
The 1051S is more than prepared to feed a big, power-hungry subwoofer all it can handle; this beast pumps out an amazing 1050 watts RMS in bridged mode, and includes a Punch Bass boost of up to 18 dB at 45 Hz! A handy wired remote for the Punch Bass comes right in the box, so you can boost the boom right from the driver's seat.
265 watts RMS x 2 at 4 ohms
525 watts RMS x 2 at 2 ohms
1050 watts RMS x 1 at 4 ohms in bridged mode
4-ohm stable in bridged mode
stereo or bridged mono output
Tri-Way capable
requires 4-gauge power and ground leads plus a 100-amp fuse and fuse holder — wiring and hardware not included with amplifier
TOPAZ noise-killing differential inputs eliminate 80% of ground loop noise between the head unit and the amp
NOMAD advanced protection circuitry monitors temperature, voltage, current and impedance, and provides "intelligent" shut-down protection without limiting system performance
TRANS•ana circuit designs keep voltages low and signal paths simple in the pre-amp section, for minimum distortion and maximum musicality
MEHSA provides more efficient transfer of heat from MOSFET output devices to the heatsink for cooler operation
preamp outputs
Punch Bass boosts bass up to 18 dB at 45 Hz (wired remote control included for fingertip control)
Link to this page
